Prusa3D Forum

Notifications

Clear all

Tammeo

Groupe: Enregistré

A(ont) rejoint: 2022/03/20

Active Member

	With all the info I’ve provided, can we go back to the initi... Dans le forum How do I print this? (Printing help)	il y a 3 years
	No to the first one, I used to print with first layer at 0.3... Dans le forum How do I print this? (Printing help)	il y a 3 years
	Here it is Dans le forum How do I print this? (Printing help)	il y a 3 years
	thank you @Diem for your reply, last quick one from my side:... Dans le forum How do I print this? (Printing help)	il y a 3 years
	here the pictures you’ve requested If yo are referring to th... Dans le forum How do I print this? (Printing help)	il y a 3 years
	last two lines of the previous post were from a draft reply,... Dans le forum How do I print this? (Printing help)	il y a 3 years
	Nice to know I'm the "example not to follow", so here's the ... Dans le forum How do I print this? (Printing help)	il y a 3 years
	3rd attempt with a Z height slightly increased by 20 microns... Dans le forum How do I print this? (Printing help)	il y a 3 years
	Advanced bed leveling on brand new mks3+ Dans le forum How do I print this? (Printing help)	il y a 3 years

Statistiques du forum

566 Forums

63.2 K Sujets

444.3 K Messages

20 En-ligne

68.1 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé