Prusa3D Forum

Notifications

Clear all

Swisscore

Grupa: Zarejestrowany

Dołączył: 2017/03/02

Active Member

	Juste to give a fast feed-back, since I fix the ground probl... In forum Hardware, firmware and software help	1 day temu
	@tim-m30 Thanks for your answer, I will try next time In forum Assembly and first prints troubleshooting	5 years temu
	Thanks to all, it was just the igus bearing who wasn't worki... In forum Assembly and first prints troubleshooting	5 years temu
	@tim-m30 Ok but I didn't find to add images, I was searching... In forum Assembly and first prints troubleshooting	5 years temu
	@joantabb This is standard ones, On my MK2s I changed like t... In forum Assembly and first prints troubleshooting	5 years temu
	@tim-m30 Thanks for answer, at first, I added a bit of greas... In forum Assembly and first prints troubleshooting	5 years temu
	Check Axis Length X In forum Assembly and first prints troubleshooting	5 years temu
	I have the same problem if the auto-home is not well done In forum Assembly and first prints troubleshooting	5 years temu

Statystyki Forum

595 Fora

69.7 K Tematy

488.2 K Posty

17 Online

80.2 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte