Prusa3D Forum

Benachrichtigungen

Alles löschen

Swisscore

Gruppe: Registriert

Beigetreten: 2017/03/02

Active Member

	My old house haven't ground, neutral and ground are together... Im Forum Hardware, firmware and software help	Vor 1 month
	Juste to give a fast feed-back, since I fix the ground probl... Im Forum Hardware, firmware and software help	Vor 2 months
	@tim-m30 Thanks for your answer, I will try next time Im Forum Assembly and first prints troubleshooting	Vor 5 years
	Thanks to all, it was just the igus bearing who wasn't worki... Im Forum Assembly and first prints troubleshooting	Vor 5 years
	@tim-m30 Ok but I didn't find to add images, I was searching... Im Forum Assembly and first prints troubleshooting	Vor 5 years
	@joantabb This is standard ones, On my MK2s I changed like t... Im Forum Assembly and first prints troubleshooting	Vor 5 years
	@tim-m30 Thanks for answer, at first, I added a bit of greas... Im Forum Assembly and first prints troubleshooting	Vor 5 years
	Check Axis Length X Im Forum Assembly and first prints troubleshooting	Vor 5 years
	I have the same problem if the auto-home is not well done Im Forum Assembly and first prints troubleshooting	Vor 5 years

Forums-Statistiken

597 Foren

70.7 K Themen

495.6 K Beiträge

13 Online

82 K Mitglieder

Forum Icons: Das Forum enthält keine ungelesenen Beiträge Das Forum enthält ungelesene Beiträge

Themen-Icons: Unbeantwortet Beantwortet Aktiv Heiß Oben angepinnt Nicht genehmigt Gelöst Privat Geschlossen