Avisos
Vaciar todo
supergimp
Grupo: Registrado
Registrado: 2023/03/30
Active Member
1
|
I did open the controller and everything looks ok. Also when... En el foro Hardware, firmware and software help |
hace 1 year | |
|
First Layer Cal leaves me stuck in endless loop asking if fi... En el foro Hardware, firmware and software help |
hace 1 year | |
| Ha. That makes sense. | hace 2 years | |
| Good to hear. Can you explain this statement: The octopi ima... | hace 2 years | |
| I'm using this setup with a 3b+ (I think):Super clean, power... | hace 2 years | |
| Yea, I'm just going to swap out the SD card. cheaper than an... | hace 2 years | |
| You're rich! | hace 2 years | |
| Thanks. I do plan to make a new microSD for my Pi with Prusa... | hace 2 years | |
| Yea I'm firmly in the Octoprint universe and would really mi... | hace 2 years |