stoofer – Activité – Prusa3D Forum

Notifications

Clear all

stoofer

Groupe: Enregistré

A(ont) rejoint: 2017/09/25

Estimable Member

	Ah, I think I see what you mean, I've just been printing a l... Dans le forum Others (Archive)	il y a 7 years
	The warping is mostly due to layer contraction, the upper la... Dans le forum Others (Archive)	il y a 7 years
	I'm having similar slightly inconsistent Z issues from day t... Dans le forum Others (Archive)	il y a 7 years
	It looks like standard bowden tube for 1.75mm filament. It'... Dans le forum Others (Archive)	il y a 7 years
	It's supposedly good to 100C Dans le forum Others (Archive)	il y a 7 years
	The alignment of the zip ties on the umbilical can cause thi... Dans le forum Others (Archive)	il y a 7 years
	Contact support and disconnect the sensor immediately. Brok... Dans le forum Others (Archive)	il y a 7 years
	Yeah, I didn't have a problem with heat until the sensor fai... Dans le forum Others (Archive)	il y a 7 years
	Same happened to me when the filament sensor was overheating... Dans le forum Others (Archive)	il y a 7 years
	Same happened to me when the filament sensor was overheating... Dans le forum Others (Archive)	il y a 7 years
	My sensor stopped working yesterday, followed by a jam in th... Dans le forum Others (Archive)	il y a 7 years
	I have a floatilla of MK3 printed benchy's now, all trying t... Dans le forum Others (Archive)	il y a 7 years
	Moving up vertically along the Z axis? Sounds like your mot... Dans le forum Others (Archive)	il y a 7 years

Page 10 / 10 Précédent

Statistiques du forum

565 Forums

63.6 K Sujets

446.2 K Messages

17 En-ligne

68.9 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé