Prusa3D Forum

Notifications

Clear all

Steve

Skupina: Registrovaný

Přidal se: 2021/08/14

Active Member

	Ok a massive thanks to everyone - it now works! The key part... In forum PrusaSlicer	před 4 years
	Hi, thanks for trying but that didn't work either. 😪 It neve... In forum PrusaSlicer	před 4 years
	Thank you - I'm getting a bit frustrated now so if you could... In forum PrusaSlicer	před 4 years
	OK, so at each colour change layer instead of selecting an e... In forum PrusaSlicer	před 4 years
	I'm afraid that didn't work... I set the extruder changes in... In forum PrusaSlicer	před 4 years
	Thanks for that. When I first enable the wipe tower it appea... In forum PrusaSlicer	před 4 years
	My printer only has a single extruder, will it still stop an... In forum PrusaSlicer	před 4 years
	Filament Towers In forum PrusaSlicer	před 4 years
	Thanks for all the replies guys, whilst obviously not what I... In forum PrusaSlicer	před 4 years
	The inside is actually more important than the outside as it... In forum PrusaSlicer	před 4 years
	Here's what the print should come out like (this was printed... In forum PrusaSlicer	před 4 years
	This is how the print comes out. This hopefully sho... In forum PrusaSlicer	před 4 years
	Yes without the 3 images I attached being visible there isn'... In forum PrusaSlicer	před 4 years
	Disable Bridging? In forum PrusaSlicer	před 4 years

Fórum Statistiky

595 Fóra

68.8 K Témata

481.1 K Příspěvky

13 Online

77.3 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed