Prusa3D Forum

Notifications

Clear all

Steve

Grupa: Zarejestrowany

Dołączył: 2021/01/26

Active Member

	Failure to return to home position after printing complete In forum Hardware, firmware and software help	2 years temu
	Hi All, So, following advice, I was online with the Prusa Ch... In forum Hardware, firmware and software help	4 years temu
	Hope this works. Attachment removed In forum Hardware, firmware and software help	4 years temu
	Hi All, @joantabb, thanks, think I figured out the drag and ... In forum Hardware, firmware and software help	4 years temu
	RE: Original Mini X axis travel issue In forum Hardware, firmware and software help	4 years temu
	Hi, spoke too soon. Original problem is still present. Sel... In forum Hardware, firmware and software help	4 years temu
	@Karl-Herbert, Thank you very much! Interestingly, factory ... In forum Hardware, firmware and software help	4 years temu
	Adding 1/27/2021: I have checked the set screw holding the ... In forum Hardware, firmware and software help	4 years temu
	Original Mini X axis travel issue In forum Hardware, firmware and software help	4 years temu

Statystyki Forum

559 Fora

63.1 K Tematy

443.9 K Posty

22 Online

68.1 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte