Prusa3D Forum

Notifications

Clear all

Steve

Skupina: Registrovaný

Přidal se: 2021/01/26

Active Member

	Failure to return to home position after printing complete In forum Hardware, firmware and software help	před 2 years
	Hi All, So, following advice, I was online with the Prusa Ch... In forum Hardware, firmware and software help	před 4 years
	Hope this works. Attachment removed In forum Hardware, firmware and software help	před 4 years
	Hi All, @joantabb, thanks, think I figured out the drag and ... In forum Hardware, firmware and software help	před 4 years
	RE: Original Mini X axis travel issue In forum Hardware, firmware and software help	před 4 years
	Hi, spoke too soon. Original problem is still present. Sel... In forum Hardware, firmware and software help	před 4 years
	@Karl-Herbert, Thank you very much! Interestingly, factory ... In forum Hardware, firmware and software help	před 4 years
	Adding 1/27/2021: I have checked the set screw holding the ... In forum Hardware, firmware and software help	před 4 years
	Original Mini X axis travel issue In forum Hardware, firmware and software help	před 4 years

Fórum Statistiky

559 Fóra

63 K Témata

443.6 K Příspěvky

20 Online

67.9 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed