Prusa3D Forum

Notifications

Clear all

Steve

Groupe: Enregistré

A(ont) rejoint: 2021/01/26

Active Member

	Failure to return to home position after printing complete Dans le forum Hardware, firmware and software help	il y a 2 years
	Hi All, So, following advice, I was online with the Prusa Ch... Dans le forum Hardware, firmware and software help	il y a 4 years
	Hope this works. Attachment removed Dans le forum Hardware, firmware and software help	il y a 4 years
	Hi All, @joantabb, thanks, think I figured out the drag and ... Dans le forum Hardware, firmware and software help	il y a 4 years
	RE: Original Mini X axis travel issue Dans le forum Hardware, firmware and software help	il y a 4 years
	Hi, spoke too soon. Original problem is still present. Sel... Dans le forum Hardware, firmware and software help	il y a 4 years
	@Karl-Herbert, Thank you very much! Interestingly, factory ... Dans le forum Hardware, firmware and software help	il y a 4 years
	Adding 1/27/2021: I have checked the set screw holding the ... Dans le forum Hardware, firmware and software help	il y a 4 years
	Original Mini X axis travel issue Dans le forum Hardware, firmware and software help	il y a 4 years

Statistiques du forum

559 Forums

63.1 K Sujets

443.9 K Messages

22 En-ligne

68.1 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé