Prusa3D Forum

Notifications

Clear all

Stephen

Grupa: Zarejestrowany

Dołączył: 2019/03/26

Active Member

	@vintagepc Thanks! Very helpful information! In forum Awesome prints (Hall Of Fame)	5 years temu
	and I found a post around max volumetric speed on these foru... In forum Awesome prints (Hall Of Fame)	5 years temu
	@vintagepc I too owe you an apology - my response was snakie... In forum Awesome prints (Hall Of Fame)	5 years temu
	@vintagepc I don't want to come across as rude either, but I... In forum Awesome prints (Hall Of Fame)	5 years temu
	Fascinating! So it may be possible to print with multiple to... In forum Awesome prints (Hall Of Fame)	5 years temu
	I've had very good luck with the techs. Many seem to have th... In forum Hardware, firmware and software help	5 years temu
	I ended up spending more than 5 hours with them as I was mak... In forum Hardware, firmware and software help	5 years temu
	I contacted Prusa support about the 0.25 nozzle and MMU. I w... In forum Awesome prints (Hall Of Fame)	5 years temu
	I was ready to return my MMU. Then I thought to contact the ... In forum Hardware, firmware and software help	5 years temu
	I am absolutely loving Autodesk Fusion 360. It took a little... In forum General discussion, announcements and releases	5 years temu

Statystyki Forum

565 Fora

63.6 K Tematy

446.3 K Posty

21 Online

69 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte