Prusa3D Forum

Notifications

Clear all

Stephen

Skupina: Registrovaný

Přidal se: 2019/03/26

Active Member

	@vintagepc Thanks! Very helpful information! In forum Awesome prints (Hall Of Fame)	před 5 years
	and I found a post around max volumetric speed on these foru... In forum Awesome prints (Hall Of Fame)	před 5 years
	@vintagepc I too owe you an apology - my response was snakie... In forum Awesome prints (Hall Of Fame)	před 5 years
	@vintagepc I don't want to come across as rude either, but I... In forum Awesome prints (Hall Of Fame)	před 5 years
	Fascinating! So it may be possible to print with multiple to... In forum Awesome prints (Hall Of Fame)	před 5 years
	I've had very good luck with the techs. Many seem to have th... In forum Hardware, firmware and software help	před 5 years
	I ended up spending more than 5 hours with them as I was mak... In forum Hardware, firmware and software help	před 5 years
	I contacted Prusa support about the 0.25 nozzle and MMU. I w... In forum Awesome prints (Hall Of Fame)	před 5 years
	I was ready to return my MMU. Then I thought to contact the ... In forum Hardware, firmware and software help	před 5 years
	I am absolutely loving Autodesk Fusion 360. It took a little... In forum General discussion, announcements and releases	před 5 years

Fórum Statistiky

565 Fóra

63.6 K Témata

446.3 K Příspěvky

19 Online

69 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed