Prusa3D Forum

Notifications

Clear all

SpaceGregor

Grupa: Zarejestrowany

Dołączył: 2020/01/01

Active Member

	While I was printing a XYZ cube I noticed that the purge lin... In forum Hardware, firmware and software help	3 years temu
	The lines on 3 prints of the same model are on different z h... In forum Hardware, firmware and software help	3 years temu
	I checked the z axis and it's fine as well. Also lubed up al... In forum Hardware, firmware and software help	3 years temu
	I checked/tightened every screw I could find, seems like it ... In forum Hardware, firmware and software help	3 years temu
	The issue also seems to be more pronounced on the Y axis. On... In forum Hardware, firmware and software help	3 years temu
	PrusaSlicer 2.4 with basically default settings. The Filamen... In forum Hardware, firmware and software help	3 years temu
	Layer shifting at various heights In forum Hardware, firmware and software help	3 years temu
	Extruder-Print head PTFE tube broke In forum Hardware, firmware and software help	3 years temu
	Specific model causes extruder to clog up In forum How do I print this? (Printing help)	5 years temu

Statystyki Forum

559 Fora

63 K Tematy

443.3 K Posty

26 Online

67.9 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte