Prusa3D Forum

Notifiche

Cancella tutti

SpaceGregor

Gruppo: Registrato

Registrato: 2020/01/01

Active Member

	While I was printing a XYZ cube I noticed that the purge lin... Nel forum Hardware, firmware and software help	4 years fa
	The lines on 3 prints of the same model are on different z h... Nel forum Hardware, firmware and software help	4 years fa
	I checked the z axis and it's fine as well. Also lubed up al... Nel forum Hardware, firmware and software help	4 years fa
	I checked/tightened every screw I could find, seems like it ... Nel forum Hardware, firmware and software help	4 years fa
	The issue also seems to be more pronounced on the Y axis. On... Nel forum Hardware, firmware and software help	4 years fa
	PrusaSlicer 2.4 with basically default settings. The Filamen... Nel forum Hardware, firmware and software help	4 years fa
	Layer shifting at various heights Nel forum Hardware, firmware and software help	4 years fa
	Extruder-Print head PTFE tube broke Nel forum Hardware, firmware and software help	4 years fa
	Specific model causes extruder to clog up Nel forum How do I print this? (Printing help)	5 years fa

Statistiche Forum

585 Forum

68 K Discussioni

476.5 K Post

10 Online

75.6 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso