Prusa3D Forum

Notifications

Clear all

SpaceGregor

Groupe: Enregistré

A(ont) rejoint: 2020/01/01

Active Member

	While I was printing a XYZ cube I noticed that the purge lin... Dans le forum Hardware, firmware and software help	il y a 4 years
	The lines on 3 prints of the same model are on different z h... Dans le forum Hardware, firmware and software help	il y a 4 years
	I checked the z axis and it's fine as well. Also lubed up al... Dans le forum Hardware, firmware and software help	il y a 4 years
	I checked/tightened every screw I could find, seems like it ... Dans le forum Hardware, firmware and software help	il y a 4 years
	The issue also seems to be more pronounced on the Y axis. On... Dans le forum Hardware, firmware and software help	il y a 4 years
	PrusaSlicer 2.4 with basically default settings. The Filamen... Dans le forum Hardware, firmware and software help	il y a 4 years
	Layer shifting at various heights Dans le forum Hardware, firmware and software help	il y a 4 years
	Extruder-Print head PTFE tube broke Dans le forum Hardware, firmware and software help	il y a 4 years
	Specific model causes extruder to clog up Dans le forum How do I print this? (Printing help)	il y a 5 years

Statistiques du forum

585 Forums

68 K Sujets

476.5 K Messages

15 En-ligne

75.6 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé