Prusa3D Forum

Notifications

Clear all

Sir Printalot

Grupa: Zarejestrowany

Dołączył: 2022/01/13

Active Member

	It was 100% clean. I used the G-code on the printer with an... In forum Bugs & Errors	1 year temu
	0.7.0 RC3 is installed, but the problem persists. See video ... In forum Bugs & Errors	1 year temu
	Amazing - thanks! In forum Bugs & Errors	1 year temu
	Hi Tojik, Thanks for the help. I updated the SD card but now... In forum Bugs & Errors	1 year temu
	Print stops and resumes In forum Bugs & Errors	2 years temu
	The issue was solved by using Prusa-Link-0.6.0. Hope this'll... In forum Bugs & Errors	2 years temu
	Can't get it to cooperate. Guess I'll have to go back to Oct... In forum Bugs & Errors	2 years temu
	Thanks, Tojik. I'll give it a go 🙂 In forum Bugs & Errors	2 years temu
	RE: Print uploads, printer starts, but stops again. In forum Bugs & Errors	2 years temu
	Print uploads, printer starts, but stops again. In forum Bugs & Errors	2 years temu
	Thanks. I tried with brim and raft to remove warping from th... In forum How do I print this? (Printing help)	3 years temu
	Sharp edge on top later In forum How do I print this? (Printing help)	3 years temu

Statystyki Forum

559 Fora

62.8 K Tematy

442.5 K Posty

21 Online

67.4 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte