Prusa3D Forum

Notifiche

Cancella tutti

Sir Printalot

Gruppo: Registrato

Registrato: 2022/01/13

Active Member

	It was 100% clean. I used the G-code on the printer with an... Nel forum Bugs & Errors	1 year fa
	0.7.0 RC3 is installed, but the problem persists. See video ... Nel forum Bugs & Errors	1 year fa
	Amazing - thanks! Nel forum Bugs & Errors	1 year fa
	Hi Tojik, Thanks for the help. I updated the SD card but now... Nel forum Bugs & Errors	1 year fa
	Print stops and resumes Nel forum Bugs & Errors	2 years fa
	The issue was solved by using Prusa-Link-0.6.0. Hope this'll... Nel forum Bugs & Errors	2 years fa
	Can't get it to cooperate. Guess I'll have to go back to Oct... Nel forum Bugs & Errors	2 years fa
	Thanks, Tojik. I'll give it a go 🙂 Nel forum Bugs & Errors	2 years fa
	RE: Print uploads, printer starts, but stops again. Nel forum Bugs & Errors	2 years fa
	Print uploads, printer starts, but stops again. Nel forum Bugs & Errors	2 years fa
	Thanks. I tried with brim and raft to remove warping from th... Nel forum How do I print this? (Printing help)	3 years fa
	Sharp edge on top later Nel forum How do I print this? (Printing help)	3 years fa

Statistiche Forum

559 Forum

62.8 K Discussioni

442.5 K Post

19 Online

67.4 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso