Prusa3D Forum

Notifications

Clear all

Simplexify

Grupa: Zarejestrowany

Dołączył: 2018/09/07

Active Member

	@cwbullet Have you tried that specific filament? Because I'm... In forum General discussion, announcements and releases	4 years temu
	@lize You're right, I was reluctant to use acetone and in al... In forum General discussion, announcements and releases	4 years temu
	Ok, so after a deep acetone wash (thanks for the tip!) and t... In forum General discussion, announcements and releases	4 years temu
	Having the same issue here, starting to think this filament ... In forum General discussion, announcements and releases	4 years temu
	@stephen-c30 Good to know! Can you elaborate a little on the... In forum Hardware, firmware and software help	5 years temu
	@wpegden I have the same problem. After one or two successfu... In forum Hardware, firmware and software help	5 years temu
	@romio I've been struggling quite a bit too with my MMU. Tur... In forum Hardware, firmware and software help	5 years temu

Statystyki Forum

559 Fora

62.9 K Tematy

442.9 K Posty

23 Online

67.7 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte