Prusa3D Forum

Benachrichtigungen

Alles löschen

Simplexify

Gruppe: Registriert

Beigetreten: 2018/09/07

Active Member

	@cwbullet Have you tried that specific filament? Because I'm... Im Forum General discussion, announcements and releases	Vor 4 years
	@lize You're right, I was reluctant to use acetone and in al... Im Forum General discussion, announcements and releases	Vor 4 years
	Ok, so after a deep acetone wash (thanks for the tip!) and t... Im Forum General discussion, announcements and releases	Vor 4 years
	Having the same issue here, starting to think this filament ... Im Forum General discussion, announcements and releases	Vor 4 years
	@stephen-c30 Good to know! Can you elaborate a little on the... Im Forum Hardware, firmware and software help	Vor 5 years
	@wpegden I have the same problem. After one or two successfu... Im Forum Hardware, firmware and software help	Vor 5 years
	@romio I've been struggling quite a bit too with my MMU. Tur... Im Forum Hardware, firmware and software help	Vor 5 years

Forums-Statistiken

559 Foren

62.9 K Themen

442.9 K Beiträge

19 Online

67.7 K Mitglieder

Forum Icons: Das Forum enthält keine ungelesenen Beiträge Das Forum enthält ungelesene Beiträge

Themen-Icons: Unbeantwortet Beantwortet Aktiv Heiß Oben angepinnt Nicht genehmigt Gelöst Privat Geschlossen