Prusa3D Forum

Notifications

Clear all

Simplexify

Skupina: Registrovaný

Přidal se: 2018/09/07

Active Member

	@cwbullet Have you tried that specific filament? Because I'm... In forum General discussion, announcements and releases	před 4 years
	@lize You're right, I was reluctant to use acetone and in al... In forum General discussion, announcements and releases	před 4 years
	Ok, so after a deep acetone wash (thanks for the tip!) and t... In forum General discussion, announcements and releases	před 4 years
	Having the same issue here, starting to think this filament ... In forum General discussion, announcements and releases	před 4 years
	@stephen-c30 Good to know! Can you elaborate a little on the... In forum Hardware, firmware and software help	před 5 years
	@wpegden I have the same problem. After one or two successfu... In forum Hardware, firmware and software help	před 5 years
	@romio I've been struggling quite a bit too with my MMU. Tur... In forum Hardware, firmware and software help	před 5 years

Fórum Statistiky

559 Fóra

62.9 K Témata

442.9 K Příspěvky

23 Online

67.7 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed