Prusa3D Forum

Notifications

Clear all

Simplexify

Group: Registered

Joined: 2018/09/07

Active Member

	@cwbullet Have you tried that specific filament? Because I'm... In forum General discussion, announcements and releases	4 years ago
	@lize You're right, I was reluctant to use acetone and in al... In forum General discussion, announcements and releases	4 years ago
	Ok, so after a deep acetone wash (thanks for the tip!) and t... In forum General discussion, announcements and releases	4 years ago
	Having the same issue here, starting to think this filament ... In forum General discussion, announcements and releases	4 years ago
	@stephen-c30 Good to know! Can you elaborate a little on the... In forum Hardware, firmware and software help	5 years ago
	@wpegden I have the same problem. After one or two successfu... In forum Hardware, firmware and software help	5 years ago
	@romio I've been struggling quite a bit too with my MMU. Tur... In forum Hardware, firmware and software help	5 years ago

Forum Statistics

559 Forums

62.9 K Topics

442.9 K Posts

18 Online

67.7 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed