Aktywność
 
Notifications
Clear all
Shoey
Shoey
Grupa: Zarejestrowany
Dołączył: 2017/04/03
Estimable Member
4
Really? a handful? What is a handful exactly? 2? 4? 50? What...

In forum Hardware, firmware and software help

7 years temu
If Prusa chooses not to acknowledge and divulge an action pl...

In forum Hardware, firmware and software help

7 years temu
I use a PI3 attached to the headers no problem. I fabricate...

In forum Others (Archive)

7 years temu
The triangle outline is called a skirt, it's used to stabili...

In forum Others (Archive)

7 years temu
No one forced anyone to pay up front. That's a straw man, ...

In forum Others (Archive)

7 years temu
all that money upfront earning interest Yes, this is one t...

In forum Others (Archive)

7 years temu
You could try analyzing the object with Meshmixer. Install...

In forum Others (Archive)

7 years temu
I’ve not yet received my printer so kind of hoping that Prus...

In forum Hardware, firmware and software help

7 years temu
Only way I can think of software fixing this is sending lowe...

In forum Hardware, firmware and software help

7 years temu
Just noticed RC5 Firmware is online @ One change of note.....

In forum Hardware, firmware and software help

7 years temu
Lot of people have had this problem including myself, most l...

In forum Others (Archive)

7 years temu
I agree that the thread does not apply to the CE mark. But i...

In forum Hardware, firmware and software help

7 years temu
Can we please stop focusing on the CE mark and focus on the ...

In forum Hardware, firmware and software help

7 years temu
This thread does have me concerned, hope someone at Prusa ca...

In forum Hardware, firmware and software help

7 years temu
Can we stop focusing on the CE mark, It's already been estab...

In forum Hardware, firmware and software help

7 years temu
This thread does have me concerned, hope someone at Prusa ca...

In forum Hardware, firmware and software help

7 years temu
Unfortunately it's both the Calibrate Z and calibration wiza...

In forum Others (Archive)

7 years temu
I had this problem when I was doing Z Calibration, kept thin...

In forum Others (Archive)

7 years temu
No thanks. Cost would be a factor here. Not everyone uses Oc...

In forum General discussion, announcements and releases

7 years temu
Try to rotate the trapezoid nut and use different holes. Don...

In forum Others (Archive)

7 years temu
Strona 2 / 5
Share: