Attività
 
Notifiche
Cancella tutti
Shoey
Shoey
Gruppo: Registrato
Registrato: 2017/04/03
Estimable Member
4
Really? a handful? What is a handful exactly? 2? 4? 50? What...

Nel forum Hardware, firmware and software help

7 years fa
If Prusa chooses not to acknowledge and divulge an action pl...

Nel forum Hardware, firmware and software help

7 years fa
I use a PI3 attached to the headers no problem. I fabricate...

Nel forum Others (Archive)

7 years fa
The triangle outline is called a skirt, it's used to stabili...

Nel forum Others (Archive)

7 years fa
No one forced anyone to pay up front. That's a straw man, ...

Nel forum Others (Archive)

7 years fa
all that money upfront earning interest Yes, this is one t...

Nel forum Others (Archive)

7 years fa
You could try analyzing the object with Meshmixer. Install...

Nel forum Others (Archive)

7 years fa
I’ve not yet received my printer so kind of hoping that Prus...

Nel forum Hardware, firmware and software help

7 years fa
Only way I can think of software fixing this is sending lowe...

Nel forum Hardware, firmware and software help

7 years fa
Just noticed RC5 Firmware is online @ One change of note.....

Nel forum Hardware, firmware and software help

7 years fa
Lot of people have had this problem including myself, most l...

Nel forum Others (Archive)

7 years fa
I agree that the thread does not apply to the CE mark. But i...

Nel forum Hardware, firmware and software help

7 years fa
Can we please stop focusing on the CE mark and focus on the ...

Nel forum Hardware, firmware and software help

7 years fa
This thread does have me concerned, hope someone at Prusa ca...

Nel forum Hardware, firmware and software help

7 years fa
Can we stop focusing on the CE mark, It's already been estab...

Nel forum Hardware, firmware and software help

7 years fa
This thread does have me concerned, hope someone at Prusa ca...

Nel forum Hardware, firmware and software help

7 years fa
Unfortunately it's both the Calibrate Z and calibration wiza...

Nel forum Others (Archive)

7 years fa
I had this problem when I was doing Z Calibration, kept thin...

Nel forum Others (Archive)

7 years fa
No thanks. Cost would be a factor here. Not everyone uses Oc...

Nel forum General discussion, announcements and releases

7 years fa
Try to rotate the trapezoid nut and use different holes. Don...

Nel forum Others (Archive)

7 years fa
Pagina 2 / 5
Condividi: