Actividad
 
Avisos
Vaciar todo
Shoey
Shoey
Grupo: Registrado
Registrado: 2017/04/03
Estimable Member
4
Really? a handful? What is a handful exactly? 2? 4? 50? What...

En el foro Hardware, firmware and software help

hace 7 years
If Prusa chooses not to acknowledge and divulge an action pl...

En el foro Hardware, firmware and software help

hace 7 years
I use a PI3 attached to the headers no problem. I fabricate...

En el foro Others (Archive)

hace 7 years
The triangle outline is called a skirt, it's used to stabili...

En el foro Others (Archive)

hace 7 years
No one forced anyone to pay up front. That's a straw man, ...

En el foro Others (Archive)

hace 7 years
all that money upfront earning interest Yes, this is one t...

En el foro Others (Archive)

hace 7 years
You could try analyzing the object with Meshmixer. Install...

En el foro Others (Archive)

hace 7 years
I’ve not yet received my printer so kind of hoping that Prus...

En el foro Hardware, firmware and software help

hace 7 years
Only way I can think of software fixing this is sending lowe...

En el foro Hardware, firmware and software help

hace 7 years
Just noticed RC5 Firmware is online @ One change of note.....

En el foro Hardware, firmware and software help

hace 7 years
Lot of people have had this problem including myself, most l...

En el foro Others (Archive)

hace 7 years
I agree that the thread does not apply to the CE mark. But i...

En el foro Hardware, firmware and software help

hace 7 years
Can we please stop focusing on the CE mark and focus on the ...

En el foro Hardware, firmware and software help

hace 7 years
This thread does have me concerned, hope someone at Prusa ca...

En el foro Hardware, firmware and software help

hace 7 years
Can we stop focusing on the CE mark, It's already been estab...

En el foro Hardware, firmware and software help

hace 7 years
This thread does have me concerned, hope someone at Prusa ca...

En el foro Hardware, firmware and software help

hace 7 years
Unfortunately it's both the Calibrate Z and calibration wiza...

En el foro Others (Archive)

hace 7 years
I had this problem when I was doing Z Calibration, kept thin...

En el foro Others (Archive)

hace 7 years
No thanks. Cost would be a factor here. Not everyone uses Oc...

En el foro General discussion, announcements and releases

hace 7 years
Try to rotate the trapezoid nut and use different holes. Don...

En el foro Others (Archive)

hace 7 years
Página 2 / 5
Compartir: