|
I am afraid I cant tell you a way to read the PINDA values, ... In forum Prusa i3 kit (Archive) |
7 years ago |
|
This problem can occur due to too much pressure of the two s... In forum Prusa i3 kit (Archive) |
7 years ago |
|
As far as I can remember my build its really just trying out... In forum Prusa i3 kit (Archive) |
7 years ago |
|
As far as I understand you, you are printing on another obje... In forum Prusa i3 kit (Archive) |
7 years ago |
|
You are not wrong, your model is.
3D printing has its limita... In forum Prusa i3 kit (Archive) |
7 years ago |
|
I am not quite sure if I get what you mean.
I double checked... In forum Hardware, firmware and software help |
7 years ago |
|
Actually, is that even possible with the PSU connected to bo... In forum Hardware, firmware and software help |
7 years ago |
|
I noticed yesterday, that the nozzle is just at the very end... In forum Hardware, firmware and software help |
7 years ago |
|
So I did some more testings.
After I calibrate Z and try to ... In forum Hardware, firmware and software help |
7 years ago |
|
Max Bed Size too small? In forum Hardware, firmware and software help |
7 years ago |
|
My guess would be that your PINDA probe triggers too early a... In forum Prusa i3 kit (Archive) |
7 years ago |
|
So possibly any movement of the walls during the print will ... In forum Prusa i3 kit (Archive) |
7 years ago |
|
Well, I guess it's really the model's fault.
The calibration... In forum Prusa i3 kit (Archive) |
7 years ago |
|
Yes, I did.
It extruded 97 mm instead of 100 mm. So no reaso... In forum Prusa i3 kit (Archive) |
7 years ago |
|
For the printer it only says "Original Prusa i3 MK2" but Lif... In forum Prusa i3 kit (Archive) |
7 years ago |
|
I am sorry for the lack of information.
Since I only printe... In forum Prusa i3 kit (Archive) |
7 years ago |
|
Uneven sides of printed part In forum Prusa i3 kit (Archive) |
7 years ago |
