Notifications
Clear all
shane.t
shane.t
Group: Registered
Joined: 2017/02/19
Eminent Member
2
It blocks airflow from hitting the filament sooner.

In forum Improvements (Archive)

7 years ago
I actually monitor it during a print and I have yet to go ab...

In forum Improvements (Archive)

7 years ago
Found a couple of minor issues with the v6b. 1. If you a...

In forum Others (Archive)

7 years ago
So 6b is safe to use either way? Just asking because I have...

In forum Others (Archive)

7 years ago
Quick question. What is the difference between v6 and v6b? ...

In forum Others (Archive)

7 years ago
I searched for quite some time, and the only way to do it se...

In forum Software (Archive)

7 years ago
I will post up some tests, but I can confirm a few things ab...

In forum Improvements (Archive)

7 years ago
Actually I think I figured out what is going on, and there w...

In forum Others (Archive)

7 years ago
I have had plenty of not happy prints using 0.3mm layer heig...

In forum Others (Archive)

7 years ago
Hmm.. I will try again, but it doesn't seem to be working. ...

In forum Others (Archive)

7 years ago
Another trick... use a can of compressed air upside down on ...

In forum Others (Archive)

7 years ago
Actually I think I figured out what is going on, and there w...

In forum Others (Archive)

7 years ago
This firmware has some major Z level issues. My Z live went...

In forum Others (Archive)

7 years ago
You know I got my socks, but I ended up pulling it off. Loo...

In forum Improvements (Archive)

7 years ago
Thanks much. Here was my solution so I didn't have to cut t...

In forum Improvements (Archive)

7 years ago
Great looking enclosure! Quick question, how did you attach...

In forum Improvements (Archive)

7 years ago
Page 2 / 2
Share: