Deutsch
Foren
Mitglieder
shane.t
Aktivität
 
Benachrichtigungen
Alles löschen
shane.t
shane.t
Gruppe: Registriert
Beigetreten: 2017/02/19
Eminent Member
2
Profil Aktivität
It blocks airflow from hitting the filament sooner.

Im Forum Improvements (Archive)

 Vor 7 years
I actually monitor it during a print and I have yet to go ab...

Im Forum Improvements (Archive)

 Vor 7 years
Found a couple of minor issues with the v6b. 1. If you a...

Im Forum Others (Archive)

 Vor 7 years
So 6b is safe to use either way? Just asking because I have...

Im Forum Others (Archive)

 Vor 7 years
Quick question. What is the difference between v6 and v6b? ...

Im Forum Others (Archive)

 Vor 7 years
I searched for quite some time, and the only way to do it se...

Im Forum Software (Archive)

 Vor 7 years
I will post up some tests, but I can confirm a few things ab...

Im Forum Improvements (Archive)

 Vor 7 years
Actually I think I figured out what is going on, and there w...

Im Forum Others (Archive)

 Vor 7 years
I have had plenty of not happy prints using 0.3mm layer heig...

Im Forum Others (Archive)

 Vor 7 years
Hmm.. I will try again, but it doesn't seem to be working. ...

Im Forum Others (Archive)

 Vor 7 years
Another trick... use a can of compressed air upside down on ...

Im Forum Others (Archive)

 Vor 7 years
Actually I think I figured out what is going on, and there w...

Im Forum Others (Archive)

 Vor 7 years
This firmware has some major Z level issues. My Z live went...

Im Forum Others (Archive)

 Vor 7 years
You know I got my socks, but I ended up pulling it off. Loo...

Im Forum Improvements (Archive)

 Vor 7 years
Thanks much. Here was my solution so I didn't have to cut t...

Im Forum Improvements (Archive)

 Vor 7 years
Great looking enclosure! Quick question, how did you attach...

Im Forum Improvements (Archive)

 Vor 7 years
Seite 2 / 2
Teilen: