Notifications
Clear all
sebastiaan.v2
Grupa: Zarejestrowany
Dołączył: 2016/12/07
Active Member
1
|
Need to adjust z more before each print - Drifting z height In forum Hardware, firmware and software help |
7 years temu | |
|
There are 2 bugs I ran into I believe.
1 - Enforce support ... In forum Software (Archive) |
8 years temu | |
|
Made some changes and now it works.
Changes:
Temperature -... In forum Others (Archive) |
8 years temu | |
|
This is the printed part. The hollow part is 8mm all way fro... In forum Others (Archive) |
8 years temu | |
|
Infill = 100%
- Layer height = 0.2mm
- First layer = 0.2mm
... In forum Others (Archive) |
8 years temu | |
|
TPU printed tube is air permeable while I need non-permeable In forum Others (Archive) |
8 years temu |