Avisos
Vaciar todo
sebastiaan.v2
Grupo: Registrado
Registrado: 2016/12/07
Active Member
1
Need to adjust z more before each print - Drifting z height En el foro Hardware, firmware and software help |
hace 7 years | |
There are 2 bugs I ran into I believe.
1 - Enforce support ... En el foro Software (Archive) |
hace 8 years | |
Made some changes and now it works.
Changes:
Temperature -... En el foro Others (Archive) |
hace 8 years | |
This is the printed part. The hollow part is 8mm all way fro... En el foro Others (Archive) |
hace 8 years | |
Infill = 100%
- Layer height = 0.2mm
- First layer = 0.2mm
... En el foro Others (Archive) |
hace 8 years | |
TPU printed tube is air permeable while I need non-permeable En el foro Others (Archive) |
hace 8 years |