Notifiche
Cancella tutti
sebastiaan.v2
Gruppo: Registrato
Registrato: 2016/12/07
Active Member
1
|
Need to adjust z more before each print - Drifting z height Nel forum Hardware, firmware and software help |
7 years fa | |
|
There are 2 bugs I ran into I believe.
1 - Enforce support ... Nel forum Software (Archive) |
8 years fa | |
|
Made some changes and now it works.
Changes:
Temperature -... Nel forum Others (Archive) |
8 years fa | |
|
This is the printed part. The hollow part is 8mm all way fro... Nel forum Others (Archive) |
8 years fa | |
|
Infill = 100%
- Layer height = 0.2mm
- First layer = 0.2mm
... Nel forum Others (Archive) |
8 years fa | |
|
TPU printed tube is air permeable while I need non-permeable Nel forum Others (Archive) |
8 years fa |