Notifications
Clear all
SeanR
Groupe: Enregistré
A(ont) rejoint: 2021/02/23
Active Member
1
|
OK, so recently contacted support and I have to adjust my re... Dans le forum Assembly and first prints troubleshooting |
il y a 4 years | |
|
I've not had any issues yet with 4.3.1 with the USB stick I ... Dans le forum Hardware, firmware and software help |
il y a 4 years | |
|
Ok, so now I have an update. I was able to actually to comp... Dans le forum Assembly and first prints troubleshooting |
il y a 4 years | |
|
Mini ripping print off the bed pla all over the extruder Dans le forum Assembly and first prints troubleshooting |
il y a 4 years | |
|
I had some weird issues with the bed on the mini not being f... Dans le forum Assembly and first prints troubleshooting |
il y a 4 years | |
|
I put a single piece of painters tape on the outside edges o... Dans le forum Assembly and first prints troubleshooting |
il y a 4 years | |
|
Hey, I followed the wizard too and I ended up with -1.485 fo... Dans le forum Assembly and first prints troubleshooting |
il y a 4 years |