Prusa3D Forum

Notifications

Clear all

Scott Clemence

Groupe: Enregistré

A(ont) rejoint: 2023/04/18

Active Member

	It was the thermistor that mounts to the fans in the chamber... Dans le forum Assembly and first prints troubleshooting	il y a 3 weeks
	Currently the back is fully open. I plan on adding another ... Dans le forum User mods	il y a 2 months
	Top Cover for the MMU3 setup Dans le forum User mods	il y a 2 months
	Thanks for the input. I feel a lot better now knowing it is... Dans le forum Assembly and first prints troubleshooting	il y a 2 months
	When I test it with my Ohm meter, I am getting an open circu... Dans le forum Assembly and first prints troubleshooting	il y a 2 months
	Thanks. I just did a visual inspection by unplugging it and... Dans le forum Assembly and first prints troubleshooting	il y a 2 months
	My shop runs around 75 °F (~24 °C). I did contact suppor... Dans le forum Assembly and first prints troubleshooting	il y a 2 months
	Chamber Mintemp error #31215 Dans le forum Assembly and first prints troubleshooting	il y a 2 months
	Adhesion isn't the problem. Both attempts the part was firm... Dans le forum Hardware, firmware and software help	il y a 1 year
	Print Shifted, what would cause that Dans le forum Hardware, firmware and software help	il y a 1 year
	Thanks. I can't believe I actually did that but I went and ... Dans le forum Hardware, firmware and software help	il y a 2 years
	Getting a warning about gcode being for a different printer Dans le forum Hardware, firmware and software help	il y a 2 years

Statistiques du forum

585 Forums

68 K Sujets

476.7 K Messages

11 En-ligne

75.7 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé