Prusa3D Forum

Notifications

Clear all

Scott Clemence

Skupina: Registrovaný

Přidal se: 2023/04/18

Active Member

	It was the thermistor that mounts to the fans in the chamber... In forum Assembly and first prints troubleshooting	před 3 weeks
	Currently the back is fully open. I plan on adding another ... In forum User mods	před 2 months
	Top Cover for the MMU3 setup In forum User mods	před 2 months
	Thanks for the input. I feel a lot better now knowing it is... In forum Assembly and first prints troubleshooting	před 2 months
	When I test it with my Ohm meter, I am getting an open circu... In forum Assembly and first prints troubleshooting	před 2 months
	Thanks. I just did a visual inspection by unplugging it and... In forum Assembly and first prints troubleshooting	před 2 months
	My shop runs around 75 °F (~24 °C). I did contact suppor... In forum Assembly and first prints troubleshooting	před 2 months
	Chamber Mintemp error #31215 In forum Assembly and first prints troubleshooting	před 2 months
	Adhesion isn't the problem. Both attempts the part was firm... In forum Hardware, firmware and software help	před 1 year
	Print Shifted, what would cause that In forum Hardware, firmware and software help	před 1 year
	Thanks. I can't believe I actually did that but I went and ... In forum Hardware, firmware and software help	před 2 years
	Getting a warning about gcode being for a different printer In forum Hardware, firmware and software help	před 2 years

Fórum Statistiky

585 Fóra

68 K Témata

476.7 K Příspěvky

11 Online

75.7 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed