Prusa3D Forum

Avisos

Vaciar todo

Scott Clemence

Grupo: Registrado

Registrado: 2023/04/18

Active Member

	It was the thermistor that mounts to the fans in the chamber... En el foro Assembly and first prints troubleshooting	hace 3 weeks
	Currently the back is fully open. I plan on adding another ... En el foro User mods	hace 2 months
	Top Cover for the MMU3 setup En el foro User mods	hace 2 months
	Thanks for the input. I feel a lot better now knowing it is... En el foro Assembly and first prints troubleshooting	hace 2 months
	When I test it with my Ohm meter, I am getting an open circu... En el foro Assembly and first prints troubleshooting	hace 2 months
	Thanks. I just did a visual inspection by unplugging it and... En el foro Assembly and first prints troubleshooting	hace 2 months
	My shop runs around 75 °F (~24 °C). I did contact suppor... En el foro Assembly and first prints troubleshooting	hace 2 months
	Chamber Mintemp error #31215 En el foro Assembly and first prints troubleshooting	hace 2 months
	Adhesion isn't the problem. Both attempts the part was firm... En el foro Hardware, firmware and software help	hace 1 year
	Print Shifted, what would cause that En el foro Hardware, firmware and software help	hace 1 year
	Thanks. I can't believe I actually did that but I went and ... En el foro Hardware, firmware and software help	hace 2 years
	Getting a warning about gcode being for a different printer En el foro Hardware, firmware and software help	hace 2 years

Estadísticas del Foro

585 Foros

68 K Temas

476.6 K Respuestas

10 En línea

75.6 K Miembros

Iconos del foro: El foro no contiene publicaciones sin leer El foro contiene publicaciones sin leer

Iconos de los Temas: No respondidos Respondido Activo Popular Fijo No aprobados Resuelto Privado Cerrado