Prusa3D Forum

Notifications

Clear all

Ryan Ewen

Grupa: Zarejestrowany

Dołączył: 2022/08/01

Active Member

	Okay so using the info from the above test I've done a bed l... In forum Hardware, firmware and software help	2 years temu
	Here's what the 3 x 3 print looks like before me doing anyth... In forum Hardware, firmware and software help	2 years temu
	I'm not familiar with the 3x3 single-layer prints. I'll see ... In forum Hardware, firmware and software help	2 years temu
	There is a smaller matching gear for this which also exhibit... In forum Hardware, firmware and software help	2 years temu
	Quality is rough towards rear of print In forum Hardware, firmware and software help	2 years temu

Statystyki Forum

565 Fora

63.9 K Tematy

447.6 K Posty

21 Online

69.5 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte