Prusa3D Forum

Notifiche

Cancella tutti

Ryan Ewen

Gruppo: Registrato

Registrato: 2022/08/01

Active Member

	Okay so using the info from the above test I've done a bed l... Nel forum Hardware, firmware and software help	2 years fa
	Here's what the 3 x 3 print looks like before me doing anyth... Nel forum Hardware, firmware and software help	2 years fa
	I'm not familiar with the 3x3 single-layer prints. I'll see ... Nel forum Hardware, firmware and software help	2 years fa
	There is a smaller matching gear for this which also exhibit... Nel forum Hardware, firmware and software help	2 years fa
	Quality is rough towards rear of print Nel forum Hardware, firmware and software help	2 years fa

Statistiche Forum

565 Forum

63.9 K Discussioni

447.6 K Post

21 Online

69.5 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso