Notifications
Clear all
Ryan Ewen
Groupe: Enregistré
A(ont) rejoint: 2022/08/01
Active Member
1
|
Okay so using the info from the above test I've done a bed l... Dans le forum Hardware, firmware and software help |
il y a 3 years | |
|
Here's what the 3 x 3 print looks like before me doing anyth... Dans le forum Hardware, firmware and software help |
il y a 3 years | |
|
I'm not familiar with the 3x3 single-layer prints. I'll see ... Dans le forum Hardware, firmware and software help |
il y a 3 years | |
|
There is a smaller matching gear for this which also exhibit... Dans le forum Hardware, firmware and software help |
il y a 3 years | |
|
Quality is rough towards rear of print Dans le forum Hardware, firmware and software help |
il y a 3 years |