Notifications
Clear all
Robin_13
Robin_13
Group: Registered
Joined: 2023/03/10
Reputable Member
5
Bridge anchoring - How does Prusa get large anchors?

In forum PrusaSlicer

1 month ago
I don't know your reasons for wanting solid objects. In mos...

In forum General discussion, announcements and releases

1 month ago
It would depend on what you want to do and what quantities. ...

In forum General discussion, announcements and releases

1 month ago
Been reading about G10 and G11 for 3D print beds. Supposed ...

In forum How do I print this? (Printing help)

1 month ago
I upgrade firmware when it came out and didn't have any ther...

In forum Hardware, firmware and software help

1 month ago
Nice looking design. If it is a good quality SD card, I dou...

In forum General discussion, announcements and releases

1 month ago
The first thing I did when I got a little good was print all...

In forum General discussion, announcements and releases

1 month ago
AI generated 3D models for printing.

In forum General discussion, announcements and releases

1 month ago
An interesting question. Not sure why but that is not he is...

In forum General discussion, announcements and releases

1 month ago
Have not noticed any issues and I have my main Firefox prett...

In forum General discussion, announcements and releases

1 month ago
Unless you have a way to automatically know what spool is be...

In forum General discussion, announcements and releases

1 month ago
It would be nice to get the part number off of the microchip...

In forum Hardware, firmware and software help

2 months ago
From what I have seen, it is only power supply related. Wit...

In forum Hardware, firmware and software help

2 months ago
Nice picture. Information like this would be useful for new...

In forum How do I print this? (Printing help)

2 months ago
Just to confirm, in picture 3, is that protrusion printed fa...

In forum How do I print this? (Printing help)

2 months ago
From my experience, this is not out of the ordinary with pri...

In forum How do I print this? (Printing help)

2 months ago
Another thing that can affect the first layer is how level t...

In forum How do I print this? (Printing help)

2 months ago
Did you let the printer heat up long enough to unload the fi...

In forum How do I print this? (Printing help)

2 months ago
Just for info, picture 3. I was printing this on its side a...

In forum How do I print this? (Printing help)

2 months ago
I did a little test with some test temperature towers I crea...

In forum General discussion, announcements and releases

2 months ago
Page 2 / 15
Share: