Notifications
Clear all
Collision detection: bed won't rise
The heat bed on my Core One+ won't rise past the screws on the right wall. When I attempt to print I get a Collision Detection error. The initial issue was that the magnetic plate was misaligned and the edge of it collided with those right side screws. I stopped the print and realigned the plate; but ever since then, the bed won't rise past those screws. Ugh. Anyone know what might be wrong, and how it can be fixed?
Posted : 02/05/2026 7:41 pm
Topic starter
answered:
RE: Collision detection: bed won't rise
Running the Z axis calibration seems to have fixed the issue.
Posted : 02/05/2026 8:25 pm
RE: Collision detection: bed won't rise
Try running the calibration tests again. May need to do a full recalibration.
Posted : 03/05/2026 2:53 am