|
I purchased a food dehydrator instead of a dedicated dryer a... In forum General discussion, announcements and releases |
6 days ago |
|
I wanted to address this specifically, as early on, I got in... In forum General discussion, announcements and releases |
6 days ago |
|
I my ramble since over the years, I have read many discussio... In forum General discussion, announcements and releases |
6 days ago |
|
Thanks. Will look at those. I have been doing some tests w... In forum PrusaSlicer |
6 days ago |
|
Hi Matthias Nagel and Artur5 My colour changing desiccant st... In forum General discussion, announcements and releases |
1 week ago |
|
Hello Tim, I do know it is a setting as I have printed diff... In forum PrusaSlicer |
1 week ago |
|
I have learned so much about water vapour, humidity and temp... In forum General discussion, announcements and releases |
2 weeks ago |
|
Wonderful video. Useful knowledge Reading the paper is edu... In forum General discussion, announcements and releases |
2 weeks ago |
|
And look at thrift shops for a small convection oven. Got o... In forum General discussion, announcements and releases |
2 weeks ago |
|
Another option is to use random seam. I find that for most ... In forum PrusaSlicer |
2 weeks ago |
|
Over extrusion on layer change. What setting to adjust this. In forum PrusaSlicer |
2 weeks ago |
|
"But my typical open RH is only 30-40%, which helps" That is... In forum General discussion, announcements and releases |
3 weeks ago |
|
There are many comments about using heat to prep the surface... In forum General discussion, announcements and releases |
3 weeks ago |
|
I just did a test with GLOOZIT Industrial sealant & adhe... In forum General discussion, announcements and releases |
3 weeks ago |
|
I will have to test printing the TPU onto the PETG. Due to ... In forum General discussion, announcements and releases |
3 weeks ago |
|
I put all my filament into sealed bins with alumina oxide de... In forum General discussion, announcements and releases |
3 weeks ago |
|
An interesting video. Will need to watch it in detail when ... In forum General discussion, announcements and releases |
3 weeks ago |
|
There are different hardnesses of TPU which are not as flexi... In forum General discussion, announcements and releases |
3 weeks ago |
|
Adhesive for TPU to PETG In forum General discussion, announcements and releases |
3 weeks ago |
|
An update to my post about accuracy. I have improved it sin... In forum General discussion, announcements and releases |
2 months ago |