Prusa3D Forum

Notifications

Clear all

Rick

Groupe: Enregistré

A(ont) rejoint: 2019/05/31

Active Member

	@bobstro Thanks, I have made the request, sounds like it's t... Dans le forum Hardware, firmware and software help	il y a 4 years
	@karl-herbert I actually wanted to use it when I have a colo... Dans le forum Hardware, firmware and software help	il y a 4 years
	That looks like a no? Do they have plans of supporting the m... Dans le forum Hardware, firmware and software help	il y a 4 years
	M118 Command Dans le forum Hardware, firmware and software help	il y a 4 years
	Nice! Not sure it is possible to have a gap internally in th... Dans le forum Assembly and first prints troubleshooting	il y a 5 years
	Mine was too but all I had to do was release the 3 bolts tha... Dans le forum Assembly and first prints troubleshooting	il y a 5 years
	Prusa emailed me back today and wanted me to retry the firmw... Dans le forum Assembly and first prints troubleshooting	il y a 5 years
	Got the new heat break installed this morning and so far two... Dans le forum Assembly and first prints troubleshooting	il y a 5 years
	And they kept telling me to try a cold pull but with the way... Dans le forum Assembly and first prints troubleshooting	il y a 5 years
	Thanks so based on that it would be beneficial to switch to ... Dans le forum Assembly and first prints troubleshooting	il y a 5 years
	So I'm very confused zen-k above said he switched to the sta... Dans le forum Assembly and first prints troubleshooting	il y a 5 years
	So would you say it would be a waste of time to replace it w... Dans le forum Assembly and first prints troubleshooting	il y a 5 years
	Does the MK3S already ship with the E3d v6 heatbreak? I look... Dans le forum Assembly and first prints troubleshooting	il y a 5 years
	Thanks I will give that a try! Dans le forum Assembly and first prints troubleshooting	il y a 5 years
	Having the same issue on 1 week old printer MKS3, worked gr... Dans le forum Assembly and first prints troubleshooting	il y a 5 years

Statistiques du forum

565 Forums

63.6 K Sujets

446.2 K Messages

20 En-ligne

68.9 K Membres

Le dernier des messages: Repeated Probing on right side of bed Notre nouveau membre: Kiley Murphy Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé