Prusa3D Forum

Benachrichtigungen

Alles löschen

Rick

Gruppe: Registriert

Beigetreten: 2019/05/31

Active Member

	@bobstro Thanks, I have made the request, sounds like it's t... Im Forum Hardware, firmware and software help	Vor 4 years
	@karl-herbert I actually wanted to use it when I have a colo... Im Forum Hardware, firmware and software help	Vor 4 years
	That looks like a no? Do they have plans of supporting the m... Im Forum Hardware, firmware and software help	Vor 4 years
	M118 Command Im Forum Hardware, firmware and software help	Vor 4 years
	Nice! Not sure it is possible to have a gap internally in th... Im Forum Assembly and first prints troubleshooting	Vor 5 years
	Mine was too but all I had to do was release the 3 bolts tha... Im Forum Assembly and first prints troubleshooting	Vor 5 years
	Prusa emailed me back today and wanted me to retry the firmw... Im Forum Assembly and first prints troubleshooting	Vor 5 years
	Got the new heat break installed this morning and so far two... Im Forum Assembly and first prints troubleshooting	Vor 5 years
	And they kept telling me to try a cold pull but with the way... Im Forum Assembly and first prints troubleshooting	Vor 5 years
	Thanks so based on that it would be beneficial to switch to ... Im Forum Assembly and first prints troubleshooting	Vor 5 years
	So I'm very confused zen-k above said he switched to the sta... Im Forum Assembly and first prints troubleshooting	Vor 5 years
	So would you say it would be a waste of time to replace it w... Im Forum Assembly and first prints troubleshooting	Vor 5 years
	Does the MK3S already ship with the E3d v6 heatbreak? I look... Im Forum Assembly and first prints troubleshooting	Vor 5 years
	Thanks I will give that a try! Im Forum Assembly and first prints troubleshooting	Vor 5 years
	Having the same issue on 1 week old printer MKS3, worked gr... Im Forum Assembly and first prints troubleshooting	Vor 5 years

Forums-Statistiken

565 Foren

63.6 K Themen

446.2 K Beiträge

21 Online

68.9 K Mitglieder

Letzter Beitrag: Print plate scratched when canceling print during priming line Unser neuestes Mitglied: Kiley Murphy Neueste Beiträge Ungelesene Beiträge Schlagwörter

Forum Icons: Das Forum enthält keine ungelesenen Beiträge Das Forum enthält ungelesene Beiträge

Themen-Icons: Unbeantwortet Beantwortet Aktiv Heiß Oben angepinnt Nicht genehmigt Gelöst Privat Geschlossen