Notifications
Clear all
redgreen
Group: Registered
Joined: 2019/07/29
Active Member
1
|
Cool. I learned that the gcode viewer has a slider on the bo... In forum PrusaSlicer |
3 years ago | |
|
Never mind. I see I toggled the "Wipe" In forum PrusaSlicer |
3 years ago | |
|
Thin supports feature type? In forum PrusaSlicer |
3 years ago | |
|
I already said that I did. Upgraded my firmware, re-calibrat... In forum Hardware, firmware and software help |
6 years ago | |
|
Good luck, kyriakos-g. I just assumed it was a PrusaSlicer i... In forum Hardware, firmware and software help |
6 years ago | |
|
This is a problem for me too. I haven't looked at the gcode,... In forum Hardware, firmware and software help |
6 years ago | |
| I see it had a dated welcome sheet, and has the 3.11 manuals... | 6 years ago | |
| How to tell Edition? | 6 years ago |