Notifications
Clear all
redgreen
Groupe: Enregistré
A(ont) rejoint: 2019/07/29
Active Member
1
|
Cool. I learned that the gcode viewer has a slider on the bo... Dans le forum PrusaSlicer |
il y a 2 years | |
|
Never mind. I see I toggled the "Wipe" Dans le forum PrusaSlicer |
il y a 2 years | |
|
Thin supports feature type? Dans le forum PrusaSlicer |
il y a 2 years | |
|
I already said that I did. Upgraded my firmware, re-calibrat... Dans le forum Hardware, firmware and software help |
il y a 5 years | |
|
Good luck, kyriakos-g. I just assumed it was a PrusaSlicer i... Dans le forum Hardware, firmware and software help |
il y a 5 years | |
|
This is a problem for me too. I haven't looked at the gcode,... Dans le forum Hardware, firmware and software help |
il y a 5 years | |
|
I see it had a dated welcome sheet, and has the 3.11 manuals... Dans le forum General discussion, announcements and releases |
il y a 5 years | |
|
How to tell Edition? Dans le forum General discussion, announcements and releases |
il y a 5 years |