Avisos
Vaciar todo
redgreen
Grupo: Registrado
Registrado: 2019/07/29
Active Member
1
|
Cool. I learned that the gcode viewer has a slider on the bo... En el foro PrusaSlicer |
hace 2 years | |
|
Never mind. I see I toggled the "Wipe" En el foro PrusaSlicer |
hace 2 years | |
|
Thin supports feature type? En el foro PrusaSlicer |
hace 2 years | |
|
I already said that I did. Upgraded my firmware, re-calibrat... En el foro Hardware, firmware and software help |
hace 5 years | |
|
Good luck, kyriakos-g. I just assumed it was a PrusaSlicer i... En el foro Hardware, firmware and software help |
hace 5 years | |
|
This is a problem for me too. I haven't looked at the gcode,... En el foro Hardware, firmware and software help |
hace 5 years | |
| I see it had a dated welcome sheet, and has the 3.11 manuals... | hace 5 years | |
| How to tell Edition? | hace 5 years |