Activity
 
Notifications
Clear all
Rainer
Rainer
Group: Registered
Joined: 2020/10/18
Honorable Member
1
Exactly my opinion. As has been mentioned here many times be...

In forum Hardware, firmware and software help

3 months ago
A Core One user with vibrations at 80 mm was instructed by s...

In forum General discussion, announcements and releases

3 months ago
A Core One user with vibrations at 80 mm was instructed by s...

In forum Assembly and first prints troubleshooting

3 months ago
Apart from the fans, my Core One is not significantly louder...

In forum General discussion, announcements and releases

4 months ago
RE: VFA Artifacts on X+Y Straight Edges

In forum Hardware, firmware and software help

4 months ago
RE: VFA Artifacts on X+Y Straight Edges

In forum Hardware, firmware and software help

4 months ago
True, you can't completely avoid it. It's about avoiding ext...

In forum Hardware, firmware and software help

4 months ago
Correct, but I would leave the belt taut.Also consider the o...

In forum Hardware, firmware and software help

4 months ago
If you have the version of the motor mount with the hole, yo...

In forum Hardware, firmware and software help

4 months ago
There's no logical explanation for this. The only thing I wo...

In forum Hardware, firmware and software help

4 months ago
Since someone posted pictures of this print, here are some f...

In forum Hardware, firmware and software help

4 months ago
I think he means the vertical alignment of the pulleys. Espe...

In forum Hardware, firmware and software help

4 months ago
Hi Jürgen,I can't confirm that. To me, the inner, shorter be...

In forum Hardware, firmware and software help

4 months ago
Phase stepping worked for me. The printer has become a littl...

In forum Hardware, firmware and software help

4 months ago
Full agreement. They probably did it more for weight reasons...

In forum Hardware, firmware and software help

4 months ago
Then of course this tip won't help you 😊 But maybe this one...

In forum Hardware, firmware and software help

5 months ago
Which filament are you using? Is filament with carbon an opt...

In forum Hardware, firmware and software help

5 months ago
Even with the Prusa fan, the temperature rises quite quickly...

In forum General discussion, announcements and releases

5 months ago
I don't think that's the reason. The normal Buddy camera als...

In forum User mods

5 months ago
ESP32

In forum User mods

5 months ago
Page 2 / 33
Share: