Prusa3D Forum

Notifications

Clear all

Raine

Skupina: Registrovaný

Přidal se: 2024/01/05

Active Member

	Well, this ended up being my fault. When I upgraded from MK3... In forum Assembly and first prints troubleshooting	před 2 years
	I spent a few hours with Pedro on support last night (PST) a... In forum Assembly and first prints troubleshooting	před 2 years
	Sadly, I've done this and it says it is "tuned". Old UI I co... In forum Assembly and first prints troubleshooting	před 2 years
	the right side of the x-carriage sits flush with the x-end i... In forum Assembly and first prints troubleshooting	před 2 years
	X-Axis calibration fails, only shows red X. How am I suppose... In forum Assembly and first prints troubleshooting	před 2 years

Fórum Statistiky

585 Fóra

68 K Témata

476.5 K Příspěvky

12 Online

75.6 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed