Prusa3D Forum

Notifications

Clear all

PYB

Group: Registered

Joined: 2022/07/19

Active Member

	Success! I changed the cooldown setting but also removed th... In forum Assembly and first prints troubleshooting	2 years ago
	Hi again, There it is, thanks! a_Foot_Rear_Left_x1.z... In forum Assembly and first prints troubleshooting	2 years ago
	Thanks for the proposal! will do it this evening after work.... In forum Assembly and first prints troubleshooting	2 years ago
	Thanks for the pointers, however what I cannot understand is... In forum Assembly and first prints troubleshooting	2 years ago
	ABS+ printing - delamination on small perimeters In forum Assembly and first prints troubleshooting	2 years ago
	That was the issue indeed, I was using a 20 teeth pulley 😞 ... In forum Assembly and first prints troubleshooting	2 years ago
	Found it! And I need to post it in case other people as fool... In forum Assembly and first prints troubleshooting	2 years ago
	So I tried with the bear firmware and it is not working 🙁 I... In forum Assembly and first prints troubleshooting	2 years ago
	That's what happens when you do not read instruction till th... In forum Assembly and first prints troubleshooting	2 years ago
	Failed x axis self-test In forum Assembly and first prints troubleshooting	2 years ago

Forum Statistics

559 Forums

63.1 K Topics

443.8 K Posts

20 Online

68 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed