Prusa3D Forum

Notifications

Clear all

PYB

Groupe: Enregistré

A(ont) rejoint: 2022/07/19

Active Member

	Success! I changed the cooldown setting but also removed th... Dans le forum Assembly and first prints troubleshooting	il y a 3 years
	Hi again, There it is, thanks! a_Foot_Rear_Left_x1.z... Dans le forum Assembly and first prints troubleshooting	il y a 3 years
	Thanks for the proposal! will do it this evening after work.... Dans le forum Assembly and first prints troubleshooting	il y a 3 years
	Thanks for the pointers, however what I cannot understand is... Dans le forum Assembly and first prints troubleshooting	il y a 3 years
	ABS+ printing - delamination on small perimeters Dans le forum Assembly and first prints troubleshooting	il y a 3 years
	That was the issue indeed, I was using a 20 teeth pulley 😞 ... Dans le forum Assembly and first prints troubleshooting	il y a 3 years
	Found it! And I need to post it in case other people as fool... Dans le forum Assembly and first prints troubleshooting	il y a 3 years
	So I tried with the bear firmware and it is not working 🙁 I... Dans le forum Assembly and first prints troubleshooting	il y a 3 years
	That's what happens when you do not read instruction till th... Dans le forum Assembly and first prints troubleshooting	il y a 3 years
	Failed x axis self-test Dans le forum Assembly and first prints troubleshooting	il y a 3 years

Statistiques du forum

565 Forums

64.5 K Sujets

451.9 K Messages

23 En-ligne

71.2 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé