Prusa3D Forum

Notifications

Clear all

PrintyKitty

Groupe: Enregistré

A(ont) rejoint: 2022/05/28

Active Member

	I too, have since downgraded to the non-IS option. The speed... Dans le forum Input Shaper (MINI)	il y a 2 years
	Following this, I was able to achieve improved results. I ti... Dans le forum Input Shaper (MINI)	il y a 2 years
	New Issues Arising from Input Shaper? Dans le forum How do I print this? (Printing help)	il y a 2 years
	Thanks for the tip! I will make the adjustments and monitor.... Dans le forum How do I print this? (Printing help)	il y a 2 years
	First Layer Issues - Strange Pattern Dans le forum How do I print this? (Printing help)	il y a 2 years
	Jeff Jordan's Life Adjust Z post appears to have resolved my... Dans le forum How do I print this? (Printing help)	il y a 2 years
	Thank you, both. I will give this a try. I was adjusting the... Dans le forum How do I print this? (Printing help)	il y a 2 years
	I seem to be having a similar issue! Dans le forum How do I print this? (Printing help)	il y a 2 years
	First Layer Surface Sticks lines are visible Dans le forum How do I print this? (Printing help)	il y a 2 years
	UPDATE 1: I had spoken to Prusa Support and work through wit... Dans le forum General discussion, announcements and releases	il y a 3 years
	Clicking Noises on Some Movements and Not Others Dans le forum General discussion, announcements and releases	il y a 3 years
	My mini has about 200 hours of print time and I have stumble... Dans le forum How do I print this? (Printing help)	il y a 3 years

Statistiques du forum

585 Forums

68.1 K Sujets

477 K Messages

11 En-ligne

75.8 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé