Peter L – Aktivita – Prusa3D Forum

Notifications

Clear all

Peter L

Skupina: Registrovaný

Přidal se: 2017/11/11

Honorable Member

	Hey everyone, I have a little issue with my mk3's y axis. Ev... In forum Others (Archive)	před 7 years
	I have two Prusas and one of them for almost a year. Since I... In forum Prusa i3 kit (Archive)	před 7 years
	Over the course of 4 years I picked up a lot and got over my... In forum Others (Archive)	před 7 years
	I experienced the same thing when I changed from PLA to PETG... In forum Others (Archive)	před 7 years
	I am not sure, if we have the same MK3. The final time is on... In forum Software (Archive)	před 7 years
	Print Timer In forum Software (Archive)	před 7 years
	When you do a live Z adjust are the (-) negative numbers low... In forum Others (Archive)	před 7 years
	This is a big gripe of mine. The market for printer filament... In forum Print tips (Archive)	před 7 years
	It is actually normal to see some slight differences in the ... In forum Prusa i3 kit (Archive)	před 7 years
	The filament sensor is an easy one to mess up, because you c... In forum Prusa i3 kit (Archive)	před 7 years
	I am around -600 currently. Is that too large of an adjustm... In forum Others (Archive)	před 7 years
	As far as I know TPU and TPE are terms that is used intercha... In forum Others (Archive)	před 7 years
	Exactly - the perimeter on the inside wasn't adhering. And y... In forum Others (Archive)	před 7 years
	Hard to explain but I've got a pic. First layer went down we... In forum Others (Archive)	před 7 years
	I hope someone else can try similar prints what I did just t... In forum Others (Archive)	před 7 years
	I've experimented a little with both. TPU seems to have a l... In forum Others (Archive)	před 7 years
	Thanks for posting some experience. This is disappointing t... In forum Others (Archive)	před 7 years
	What sort of print problems did you have at higher temperatu... In forum Others (Archive)	před 7 years
	Check to make sure the screws holding the gear to the X axis... In forum Prusa i3 kit (Archive)	před 7 years
	I've got my Palette+ working (mostly) with my MK3, and had s... In forum Others (Archive)	před 7 years

Stránka 28 / 33 Předchozí Další

Fórum Statistiky

565 Fóra

63.9 K Témata

447.6 K Příspěvky

21 Online

69.5 K Uživatelé

Poslední Příspěvek: Single layer failure - no or poor adhesion Nový Uživatel: SilenceDIY Recent Posts Unread Posts Tags

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed